***This is the DIY kit with nothing drilled or pre-assembled!
This is the DIY kit for EX cloner. Please watch our video below to understand how to assemble this machine - it does not come with printed instructions! - Gary
Kit includes:
13 gallon Ez-Stor bucket
Ez-Stor lid
4 up to 27 - Ex-Cloner collars
4 up to 27 - soft neoprene's
10 feet of 3/4 inch tubing (you will use about 6 feet)
5 - 3/4 elbows
1 - 3/4 tee
250 gallon per hour pump (you need to set it up to run inline per instructions)
2 - 3/4 inch drain bulkheads
10 - red misters (2 are extras)
1 - EX Cloner sticker
***This is the DIY kit with nothing drilled or pre-assembled!
Holes are Drilled with 1 7/8" Hole Saw
1 Review Hide Reviews Show Reviews
-
2 weeks and I quit
I really wanted to like this, but it was a huge waste of $140 for me, personally. It's hard to rate a DIY so low, but the issues aren't with the parts that I did. The lid leaks, not from where I drilled holes but from where it locks on. It doesn't lock tight enough on the bucket, so the water builds up around the rim and drips off the corners. I put it in an AutoPot Tray2Grow that's turned off, and the cloner flooded the tray from dripping overnight. Today, after just 2 weeks of ownership, the pump decided to stop working. Nothing happens when I plug it in. Absolutely would NOT buy again. *** Note from PAH - The pump has a 1 year warranty please email us so we can send another, if anyone has lid leak issues turn the mister that is shooting at the leaking area so it is not pointed directly where lid meets bucket and it wont leak after that. - Gary***
